DMC-300SC/B - D-Link DMC-300SC Media Converters

All media converters in this system come with their own solid metal case housing, LED status indicators and AC to DC power Adaptors. They can be used as stand-alone converters, or installed in the chassis. If you install them in the chassis, you will remove their metal cases and slide in their PC boards into the chassis slots. The chassis's power supply will be used instead of the media converters' own AC to DC power Adaptors. All media converters are hot-swappable when used with the chassis.
For use with the CMC-1000 chassis, these converters convert 10/100Mbps 10BASE-T/ 100BASE-TX Fast Ethernet twisted-pair signals to 100BASE-FX Fast Ethernet multi-mode fibre signals. Maximum fibre cable distance is 2km. 1 RJ-45 twisted-pair port and 1 fibre port are provided. This allows you to connect longer distance fibre cables between devices that are designed only for shorter distance cables, such as the Cat. 5 twisted-pair cable.

Interfaces/Ports
Connector Type	Connector End 1: , Connector End 2:
Fiber Ports	1 x SC Connector
Supported Cable Distance (Maximum)	2 km
RJ-45 Ports	1 x RJ-45
Shipping
Shipping Pallet Dimensions	(W) x (D) x (H) - Weight
Shipping Carton	containing a total of
Shipping Carton Dimensions	(W) x (D) x (H) - Weight
Trade Carton	containing a total of
Trade Carton Dimensions	(W) x (D) x (H) - Weight
Shipping Pallet	containing a total of
Compliance
Certifications	VCCI Class B • CE Class B • C-Tick
Electrical
Voltage	7.5 VAC
Current	1.5 Amps
Power Adaptor Type	External
Environmental
Environmental	Operating Temperature 0 to 40 °C - Humidity 10 to 90 %
Physical
Form Factor	Rack Module
Case Colour	Black
LED Status Indicators	Power 100Mbps Speed (for twisted-pair port) • Full Duplex/Collision (for twisted-pair and fibre ports) • LINK/ACT (for twisted-pair port)
Dimensions	2.5 cm (W) x 8.8 cm (D) x 12.0 cm (H) - Weight

• One-channel media conversion between 10BASE-T/ 100BASE-TX and 100BASE-FX

• Fiber MT-RJ or SC connector

• Auto negotiation of speeds and duplex modes on twisted-pair port

• Auto MDI-II and MDI-X

• One slide switch for configuring fixed half/full duplex modes

• Store-and-forward mechanism

• Back-pressure & IEEE 802.3x Flow Control compliant

• Full wire-speed forwarding rate

• Front panel status LEDs

• Can be used as a stand-alone device or with chassis

• Hot-swappable when used with chassis