KVR1066D3N7K3/3G - Kingston Memory 3GB PC3-8500 1066MHz DDR3 Non-ECC CL7 DIMM Memory Kit (Kit of 3)

DDR3 is the third generation of Double Data Rate (DDR) SDRAM memory. Similar to DDR2, it is a continuing evolution of DDR memory technology that delivers higher speeds (up to 1600 MHz), lower power consumption and heat dissipation. It is an ideal memory solution for bandwidth hungry systems equipped with dual and quad core processors and the lower power consumption is a perfect match for both server and mobile platforms. Dual In-line Memory Modules, or DIMMs, closely resemble SIMMs. Like SIMMs, most DIMMs install vertically into expansion sockets. The principal difference between the two is that on a SIMM, pins on opposite sides of the board are tied together to form one electrical contact; on a DIMM, opposing pins remain electrically isolated to form two separate contacts.
ValueRAM's KVR1066D3N7K3/3G is a triple-channel kit consisting of three 128M x 64-bit 1GB (1024MB) DDR3- 1066 CL7 SDRAM (Synchronous DRAM) memory modules, based on eight 128M x 8-bit DDR3-1066 FBGA components per module. Total kit capacity is 3GB (3072MB). The SPDs are programmed to JEDEC standard latency 1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V.

Memory
Memory Size	3072 MB ( 3 module(s) x 1024 MB )
Memory Type	DDR3
Memory Speed	1066 MHz
Memory Package	DIMM
Designation	PC3-8500
Pin Configuration	240 pins
Error Correction	Non ECC Unbuffered
CAS Latency	CL7
Connector Material	Gold
Module Configuration	128Mx64
Electrical
Voltage	1.5 V
Physical
Form Factor	240-Pin DIMM Module Kit
Dimensions	(W) x (D) x (H)

• JEDEC standard 1.5V ± 0.075V Power Supply

• VDDQ = 1.5V ± 0.075V

• 533MHz fCK for 1066Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 6,7,8,9

• Posted CAS

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• Programmable CAS Write Latency(CWL) = 7(DDR3-1066)

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C

• Asynchronous Reset

• PCB : Height 1.180 inch (30.00mm), single sided component

Lifetime