KVR1333D3N9K3/3G - Kingston ValueRAM 3GB (3x1GB) 1333 MHz DDR3 SDRAM Unbuffered Non-ECC CL9 DIMM Memory Module (Kit of 3)

DDR3 is the third generation of Double Data Rate (DDR) SDRAM memory. Similar to DDR2, it is a continuing evolution of DDR memory technology that delivers higher speeds (up to 1600 MHz), lower power consumption and heat dissipation. It is an ideal memory solution for bandwidth hungry systems equipped with dual and quad core processors and the lower power consumption is a perfect match for both server and mobile platforms. Dual In-line Memory Modules, or DIMMs, closely resemble SIMMs. Like SIMMs, most DIMMs install vertically into expansion sockets. The principal difference between the two is that on a SIMM, pins on opposite sides of the board are tied together to form one electrical contact; on a DIMM, opposing pins remain electrically isolated to form two separate contacts.
Kingston ValueRAM delivers the same reputable, high-quality, Kingston memory modules you've known for years at competitive prices for the white box market. Kingston ValueRAM offers a broad line of modules for customers seeking the best cost/value memory.

Memory
Memory Size	3072 MB ( 3 module(s) x 1024 MB )
Memory Type	DDR3
Memory Speed	1333 MHz
Memory Package	DIMM
Designation	PC3-10600
Pin Configuration	240 pins
Data Width	64 bit
Bus I/O Configuration	Unbuffered
Error Correction	Non ECC
CAS Latency	CL9
Connector Material	Gold
Module Configuration	128Mx64
Electrical
Voltage	1.5 V
Physical
Form Factor	240-Pin DIMM Module Kit
Dimensions	(W) x (D) x (H)

• JEDEC standard 1.5V ± 0.075V Power Supply

• VDDQ = 1.5V ± 0.075V

• 667MHz fCK for 1333Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 6,7,8,9

• Posted CAS

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• Programmable CAS Write Latency(CWL) = 9(DDR3-1333)

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C

• Asynchronous Reset

• PCB Height: 1.180 inch (30.00mm), single sided component

Lifetime Warranty