KVR1333D3D8R9SL/4G - Kingston ValueRAM 4GB Memory Module 1333 MHz DDR3 SDRAM ECC CL9 DIMM

DDR3 is the third generation of Double Data Rate (DDR) SDRAM memory. Similar to DDR2, it is a continuing evolution of DDR memory technology that delivers higher speeds (up to 1600 MHz), lower power consumption and heat dissipation. It is an ideal memory solution for bandwidth hungry systems equipped with dual and quad core processors and the lower power consumption is a perfect match for both server and mobile platforms. Dual In-line Memory Modules, or DIMMs, closely resemble SIMMs. Like SIMMs, most DIMMs install vertically into expansion sockets. The principal difference between the two is that on a SIMM, pins on opposite sides of the board are tied together to form one electrical contact; on a DIMM, opposing pins remain electrically isolated to form two separate contacts.
Kingston ValueRAM delivers the same reputable, high-quality, Kingston memory modules you've known for years at competitive prices for the white box market. Kingston ValueRAM offers a broad line of modules for customers seeking the best cost/value memory.

Memory
Memory Size	2048 MB ( 1 module(s) x 2048 MB )
Memory Type	DDR3
Memory Speed	1333 MHz
Memory Package	DIMM
Pin Configuration	240 pins
Error Correction	ECC
CAS Latency	CL9
Connector Material	Gold
Environmental
Operating Temperature	0 to 85 °C
Non Operating Temperature	-55 to +100 °C
Physical
Form Factor	240-Pin DIMM Module
Dimensions	(W) x (D) x (H)

• JEDEC standard 1.5V ± 0.075V Power Supply

• VDDQ = 1.5V ± 0.075V

• 667MHz fCK for 1333Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 5,6,7,8,9,10

• Posted CAS

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

• Bi-directional Differential Data Strobe

• Internal (self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C

• Asynchronous Reset

• PCB : Height 2.401 inch (61.00mm) with heatsink, double sided component

Lifetime Warranty